Transmission Question

Discussion in 'General Motoring' started by davebz1a, Aug 21, 2004.

  1. davebz1a

    davebz1a Guest

    I have a 96 Grand Voyager with a 41 4 speed Transmission. I had it
    replaced at 53k with a Chrysler factory rebuilt. It came with a
    36/36,000k warranty. I have 3k and 1 month left on the warranty. It
    doesn't seem to downshift properly. It doesn't happen all the time,
    but mostly when going up steep hills. It will bog down unless you down
    shift by pressing on the accelerator. Then it kicks down sometimes
    into second gear, and won't come out until the road levels off.
    Sometimes when you are rolling to a stop, you can feel it release,
    almost like it's getting stuck (like the GM's lock up torque
    converter). The fluid was completely changed at 27k, and replaced with
    Castrol ATF-3. The recommend one for Chrysler products. Any
    suggestions?
     
    davebz1a, Aug 21, 2004
    #1
  2. Oof. This doesn't help you now, but that was the wrong thing to do. Not
    only is it almost certain that you did not need a replacement transmission
    (rather a limited-scope repair or replacement of a failed sensor on
    your original) but also the factory remanufactured transmissions have a
    very poor service record.
    Get it in *now* to a competent transmission diagnostician for proper
    diagnosis. You don't have much time left before the warranty's toast.
     
    Daniel J. Stern, Aug 21, 2004
    #2
  3. davebz1a

    jdoe Guest

    First make sure your engine is running properly. Has it been tuned? Scanned
    for codes? Look paricularly at the O2 sensors and R&R and THOROUGHLY clean
    the throttle body etc.As far as needing to kick down to make a hill. THis is
    what it should do. The little bump coming to a stop can also be quite normal
    but can also be helped with a properly running (idling) engine and this
    can't happen if there is a problem i.e. a dirty throttle body. Last due to
    it coming close to warranty you may be a little paranoid about it.
    Larry
     
    jdoe, Aug 22, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.