Transaxle Swap Duster/Sundance problem

Discussion in 'General Motoring' started by ed_engelmann, Sep 8, 2006.

  1. ed_engelmann

    ed_engelmann Guest

    When replacing the transaxle from a 93 sundance into a 94 duster, when
    I have it all bolted together it will not spin. The engine turns and
    the tranny turn before install but not after. Is there a common mistake
    I seem to be stuck?
     
    ed_engelmann, Sep 8, 2006
    #1
  2. ed_engelmann

    kmatheson Guest

    I know that this may seem obvious, but did all the flexplate to
    torque-converter bolts get installed correctly?

    -KM
     
    kmatheson, Sep 8, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. looking for a duster

  2. 1997 1/2 voyager 3.0L 3spd transaxle, 75000mi, just blew up the transmission.

  3. 1994 Plymouth Sundance 2.2 engine swap

  4. Dune Buggy with FWD Mopar Engine/Transaxle Combo

  5. Left Transaxle Shaft Seal

  6. Omni-Horizon transaxle and engine attach points

  7. dead sundance and duster after going over a bump

  8. 1992 New Yorker Transaxle Issue

Loading...