Tranny problem

Discussion in 'General Motoring' started by Jesse, Nov 16, 2004.

  1. Jesse

    Jesse Guest

    Hello All,
    I recently acquired a '91 Fifth Ave with a 3.3lL engine.
    On my last trip back in June, I drove it from New York to Illinois with no
    trouble.
    Thought I would keep it as a winter car (to save my '89 New Yorker which is
    in much better condition)
    It had been stored in the garage with stabil in the fuel and it starts right
    up.

    My problem is that it does not shift. It feels like it's stuck in second
    gear.
    It does not race excessively on my last few test drives. When I drive
    45-50mph, and shift from OD - D there is no change. When I drive on manual
    1st., it runs the same (up to 45-50 mph) as when it's on OD - D.

    Winter is here and I'd like to try to get this vehicle running.
    Anyone have any suggestions?
    I checked the tranny fluid and its at the proper level and does not smell
    burnt.

    Thank you in advance.

    Jesse
     
    Jesse, Nov 16, 2004
    #1
  2. Jesse

    John Kunkel Guest

    The transmission has gone into "limp mode", read up on the subject:

    http://www.autotransinc.com/limp.htm
     
    John Kunkel, Nov 16, 2004
    #2
  3. It is. That is the transmission's "limp-home" (fault) mode, designed to
    get you to the nearest repair facility instead of stranding you on the
    spot when the transmission has a problem. This was a foolish feature for
    Chrysler to have included on the transmission, for it causes people to
    keep driving and driving and driving when the transmission has a problem.
    This 2nd-gear-only mode places extreme stress on the transmission, and so
    frequently what started as a minor problem becomes a major and expensive
    one in relatively short order.
    STOP DRIVING IT! Get it in to a competent transmission diagnostician. The
    problem could be as simple as a faulty electrical connection or a bad
    speed sensor.

    DS
     
    Daniel J. Stern, Nov 16, 2004
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.