Q: 96 Voyager Hub stiff???

Discussion in 'Voyager' started by Hola, Apr 2, 2004.

  1. Hola

    Hola Guest

    Hello,

    I have an 96 Plymouth Voyager SE and I changed the CV axle, rotors and Brake
    pads. I noticed the when turning the hub it seemed stiff to spin and was
    wondering if anyone knew how free they are supposed to rotate. Is it
    possible the bearing grease has gone bad or the bearings worn???
    Any help on the subject would be appreciated.

    Thanks,

    Greg

    1996 Plymouth Grand Voyager SE
    3.3L 4spd OD
     
    Hola, Apr 2, 2004
    #1
  2. Hola

    David Allen Guest

    If the bearing has gone bad it will be manifested by a grinding noise as you
    drive at highway speeds and are turning slightly in the direction of the
    bearing. It will probably also be loose as you jiggle the wheel (raise
    front end, grab wheel top and bottom and jiggle... there should be no
    movement).

    The bearing can be a bit stiff to turn by hand, but that shouldn't be a
    problem.
     
    David Allen, Apr 3, 2004
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Problems with 1998 Grand Voyager Check Engine Light - The saga continues

  2. Rear hub overheating on 95 Cirrus

  3. FA: Set of 4 MOPAR - Chrysler NOS Newport wheel covers / hub caps in original boxes

  4. Concorde front Hub and Bearing

  5. '77 New Yorker Hub cap.

  6. Hobbled Chrysler plans to stiff taxpayers for $3.7 billion

  7. Wheel hub problem with my 2000 Concorde

Loading...