need help

Discussion in 'General Motoring' started by rance, Jan 7, 2006.

  1. rance

    rance Guest

    1996 chrysler town & country has bad vibration under slight load (uphill)
    RPM stays same,motor mounts have been replaced.
     
    rance, Jan 7, 2006
    #1
  2. rance

    Dave Parrillo Guest

    Very commonly caused by a worn cv joint, usually inner joint. Usually
    cheaper to buy rebuilt halfshaft(axle) assembly.
     
    Dave Parrillo, Jan 7, 2006
    #2
  3. rance

    wonecold1 Guest

    It could be a leaking MAP Sensor. I have a 1996 T&C myself, and it can also
    cause a feeling of a miss. Also have you changed your tranny filter lately?
    The 604A's can be very touchy.
     
    wonecold1, Jan 7, 2006
    #3
  4. rance

    maxpower Guest

    Possibly a broken cord in one of the tires (rotate to eliminate) or a faulty
    inner cv joint ( normally on the passenger side)

    Glenn Beasley
    Chrysler Tech
     
    maxpower, Jan 7, 2006
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. need some help...

  2. T&C need help with heat

  3. Need help on starter problem

  4. possible vacuum leak, need help

  5. need help

  6. Big Purchase Mistake - In need of serious help!

  7. Need Help with ABS Trouble Codes (1995 Plymouth Grand Voyager)

  8. Help! Need help choosing "tune-up" parts.

Loading...