Jeep Liberty heater/AC blower runs only on high (# 4 setting)

Discussion in 'General Motoring' started by Pete E. Kruzer, May 16, 2009.

  1. The blower runs only on high in my daughter's Jeep Liberty.
    Any ideas on the cause of this? Is it a part I could replace for her?
     
    Pete E. Kruzer, May 16, 2009
    #1
  2. Pete E. Kruzer

    Joe Pfeiffer Guest

    Sounds like a classic blower motor resistor. Easy to replace on most
    vehicles; don't know about the Liberty.
     
    Joe Pfeiffer, May 16, 2009
    #2
  3. blower resistor is bad and its under the pass side dash 2 5/16 screws hold
    it in about 25 bucs at dealer of aftermarket
     
    man of machines, May 16, 2009
    #3
  4. Pete E. Kruzer

    Joe Pfeiffer Guest

    The Liberty uses SAE fasteners?
     
    Joe Pfeiffer, May 16, 2009
    #4
  5. 8mm is the same as 5/16 as far as sockets are concerned
     
    man of machines, May 23, 2009
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.