Help for my Cummins

Discussion in 'General Motoring' started by killermrob83, Mar 5, 2006.

  1. killermrob83

    killermrob83 Guest

    Wasn't sure where to post this thread, but thought I'd try here. Any
    direction will be greatly appreciated. I am pulling my 5.9L Cummins
    engine out of my '90 D250 to do some restoration/customization on the
    frame. I cannot leave it on the engine puller for as long as I will
    need to have it out of the vehicle. Is there an engine stand out there
    for these motors? Any ideas on how to construct one? I've been
    attempting (on paper) to design a cradle that I can set the engine down
    into that would hold it in place by bolting it down with the motor
    mounts. Any suggestions/help will again be greatly appreciated!
    Thanks,
    Rob
     
    killermrob83, Mar 5, 2006
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Stratus f* problem for 1.5years!!help

  2. 94 Chrysler Town and Country ABS HELP! HELP!

  3. Not quite on topic, but a plea for help!

  4. HELP - Timing for 2.5L 1992

  5. 94 Acclaim right engine mount help. for 6 cyl.

  6. Help! Need help choosing "tune-up" parts.

  7. HELP!!! Gona have me one 300C Touring Disel... HELP!!!

  8. No help or wrong help for Detroit?

Loading...