dead sundance and duster after going over a bump

Discussion in 'General Motoring' started by mr.snakeman, Dec 27, 2006.

  1. mr.snakeman

    mr.snakeman Guest

    I have a 1993 duster and a 1993 sundance (the parts car I bought to
    hopefully fix the duster). Both 2.5 litre non-turbo.They both died
    after going over a bump. No computer codes (as in it does not display
    ANY flashes of the codes!), engine turns over great. I bought the
    sundance for the computer, coil, distributer etc. IT IS NONE OF THESE!
    It's also not the relay set under the hood. Anyone know what the
    problem is? After a big bump- instant shut off never to re-start again!
    fusible link??? help!!!
     
    mr.snakeman, Dec 27, 2006
    #1
  2. mr.snakeman

    aarcuda69062 Guest

    If you can not get any flash codes by cycling the ignition key
    three times, the next logical step would be to verify 12 volt
    battery feed, 12 volt ignition feed and grounds at the SBEC.
     
    aarcuda69062, Dec 27, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 95 Concorde stalls when hit a bump

  2. '95 LHS Turn Signal/Hazards dead after tranny rebuild

  3. Getting my car going after long break

  4. 96 Sebring Convertible Tach and Speedo going up and down like crazy

  5. Transaxle Swap Duster/Sundance problem

  6. Does PT run better after battery goes dead?

  7. Will the Challenger keep going into 2009 and beyond?

  8. 2004 3.3 Town and Country. Engine runs rough and stalls after filling gas.

Loading...