'99 Intrepid - turn signal cam

Discussion in 'General Motoring' started by Randy, Jul 25, 2005.

  1. Randy

    Randy Guest

    I need to change the turn signal cam in my '99 Intrepid. Does anyone
    have instructions for the procedure?
    My biggest concern with this repair is that I want to make sure that
    I've disabled the air bag system properly. I've heard that all I have
    to do is disconnect the battery and that will do it. Is this correct?
     
    Randy, Jul 25, 2005
    #1
  2. Randy

    maxpower Guest

    There is no cam. Are you referring to the multifunction switch?
    1.. Open hood and disconnect the negative battery cable remote terminal
    from the remote battery post
    2.. Remove tilt lever.
    3.. Remove both upper and lower steering column shrouds.
    4.. Remove multi-function switch mounting screws and connectors
    Glenn Beasley
    Chrysler Tech
     
    maxpower, Jul 25, 2005
    #2
  3. Randy

    Randy Guest

    Yes, I suppose I am referring to the multifunction switch. I assummed
    that there was some sort of cam in there that holds the signal switch
    in place during a turn. When I signal to the right, the signal switch
    has to be held there while when turning left the switch works normally.
    Does this mean I have to change out the whole multifunction switch?
     
    Randy, Jul 26, 2005
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Lebaron Turn Signal Sound Too Soft

  2. Left hand turn signal DOA

  3. '95 LHS Turn Signal/Hazards dead after tranny rebuild

  4. T&C 96....turn signal problem

  5. 1997 Intrepid turn signal problems

  6. Turn signal fixed...

  7. Location of cam sensor 99 3.2 intrepid

  8. 2003 Dodge intrepid 2.7 engine cam tone ring swap question?

Loading...