96 Chrysler T&C Mini Van Air Conditioning

Discussion in 'General Motoring' started by clantonab, Sep 16, 2005.

  1. clantonab

    clantonab Guest

    My Mini-Van's AC just quit working the other day... was working fine one
    day, then the next it wasn't doing anything but pumping out hot air....
    Checked all fuzes (both in compartment & under hood) and all were fine.

    Question: Seems to be a fuzable link or something on top of the
    Compressor... could this have blown? Also, were is the low-pressure
    switch, and how would I (non-mechanic) check/fix all of this?

    Thanks for helping a brother out.

    Drew
     
    clantonab, Sep 16, 2005
    #1
  2. clantonab

    Bob Shuman Guest

    Most times when the compressor won't run there is a leak or the refrigerant
    is low. Have you tried bypassing the low refrigerant switch and if so, does
    the AC compressor run normally? If so, then you have leak. If not, then
    continue troubleshooting the control circuit.

    Bob
     
    Bob Shuman, Sep 16, 2005
    #2
  3. clantonab

    clantonab Guest

    Have not tried bypassing low refrig switch... how do you do that?
     
    clantonab, Sep 16, 2005
    #3
  4. clantonab

    kmatheson Guest

    Find the sensor. It most likely will be on the refrigerant line near
    the firewall. Remove the connector from the sensor, and short the two
    contacts together. The compressor clutch should engage at this point,
    if the refrigerant is low.

    This is how I found out that the seals on the connectors where they
    connect to the compressor had failed on my Voyager.

    -Kirk Matheson
     
    kmatheson, Sep 17, 2005
    #4
  5. clantonab

    Bob Shuman Guest

    A good way to easily short the connector's two leads is to use a paperclip.
    Good luck! Do report what you find.

    Bob
     
    Bob Shuman, Sep 17, 2005
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.