89 Dynasty 3.0 half-shaft

Discussion in 'General Motoring' started by Marc O. Weinmann, Aug 11, 2003.

  1. Marc O. Weinmann

    Marc O. Weinmann Guest

    Hi.. i'm getting ready to replace both half-shafts in an 89 Dynasty
    automatic. From what I read they click in and out of the transaxle. What I
    need to know is if it is alright to change then simultaneously, or do they
    need to be done one at a time?

    Thanks,
    Marc
     
    Marc O. Weinmann, Aug 11, 2003
    #1
  2. Marc O. Weinmann

    Steve Stone Guest

    I just pulled the halfshafts on my 88 New Yorker 3.0 to change the CV boots.
    No trouble doing both at once as long as you keep all the parts on the
    proper side.
     
    Steve Stone, Aug 11, 2003
    #2
  3. Marc O. Weinmann

    ulas cosar coskun Guest

    there is no problem if you do just one side.

     
    ulas cosar coskun, Aug 11, 2003
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 42LE tranny: Bad short shaft bearing - possible easy fix (adjuster)?

  2. Half of a Stereo.

  3. trouble changing CV joint ( half shaft) 93 Grand Caravan

  4. Delphi Proposal to Cut Wages in Half!

  5. Front Drive Axle ('half shaft") replacement - 2001 Intrepid

  6. 1995 Voyager half shaft woes

  7. heat working in half the minivan

  8. Energy Bill Has Only Half a Tank

Loading...