88 New Yorker Power Seat problem

Discussion in 'General Motoring' started by Steve Stone, Jun 19, 2004.

  1. Steve Stone

    Steve Stone Guest

    My 88 New Yorker 50/50 power seat is acting up on the drivers side. This uses a 3 armature
    motor and the motor is working fine however the cable that drives the front of the seat up
    and down is slipping at the transmission side of the cable (the drive at the seat track).
    The connection at the motor is firm and tight. I can feel the cable turning when I apply
    power to the motor.

    Are the cables attached to the drive transmission with a set screw or is the cable end
    squared off and just pushed into a slot ? Trying to figure out if this is a busted drive
    cable or a seat track transmission problem.

    Thanks

    Steve
     
    Steve Stone, Jun 19, 2004
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 92 new yorker oil pressure problem

  2. 90 New Yorker Odometer Problem

  3. Climate control problem/90 New Yorker Landau

  4. 1994 Chrysler New Yorker - Power Windows and Air Dies - Electrical?

  5. My '89 Chrysler New Yorker looses power in hot weather

  6. The engine fan? (was: My '89 Chrysler New Yorker looses power in hot weather)

  7. Curt trailer hitch #12025

Loading...