300 m heater controls

Discussion in 'Chrysler 300' started by Fiberman, Sep 28, 2005.

  1. Fiberman

    Fiberman Guest

    There is a little fan on the rear side of the fan speed control on the
    heater controls that keeps running even when the car is off. Is there any
    way to fix this?
     
    Fiberman, Sep 28, 2005
    #1
  2. Fiberman

    Bill Putney Guest

    When you say it "keeps running" - do you mean runs for a minute or so
    then cuts off (normal), or never shuts off (not normal)?

    Bill Putney
    (To reply by e-mail, replace the last letter of the alphabet in my
    address with the letter 'x')
     
    Bill Putney, Sep 28, 2005
    #2
  3. Fiberman

    maxpower Guest

    It is called the in car aspirator motor
    Your vihicle is equipped with ATC system, each time you open the door of
    the vehicle that motor turns on for about 2 min and samples the temp in the
    vehicle. when you are driving the car or the ignition switch is on that
    motor will always run even when the ATC system head "off" button is pushed.
    If it is noisy try blowing the acumulated dust off of it.

    Glenn Beasley
    Chrysler Tech
     
    maxpower, Sep 28, 2005
    #3
  4. Fiberman

    maxpower Guest

    It is called the in car aspirator motor
    Your vihicle is equipped with ATC system, each time you open the door of
    the vehicle that motor turns on for about 2 min and samples the temp in the
    vehicle. when you are driving the car or the ignition switch is on that
    motor will always run even when the ATC system head "off" button is pushed.
    If it is noisy try blowing the acumulated dust off of it.

    Glenn Beasley
    Chrysler Tech
     
    maxpower, Sep 28, 2005
    #4
  5. Fiberman

    Fiberman Guest

    thank you everybody, I will try to blow the dust out
     
    Fiberman, Sep 29, 2005
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.