2002 Concorde electric seat stuck

Discussion in 'Concorde' started by wr2002, Jul 13, 2007.

  1. wr2002

    wr2002 Guest

    The driver's side electric seat is stuck and makes a grinding noise when I
    try to adjust it. It is stuck with the front part (under my knee area) up
    and does not let my legs reach the pedals well. I can adjust the seat back
    to sit up or recline and the whole seat will move forward and back. I just
    can't get the front part to lower any more. The rear part will go up and
    down but not the front. Any suggestions? Help, I can't drive my car like
    this!

    WR
     
    wr2002, Jul 13, 2007
    #1
  2. wr2002

    april1st Guest

    I had this happen to me on '00 Intrepid -- unfortunately, in my case
    the problem was that something inside the reducer of the electric
    motors that drives the worm screw that adjust the height of the front
    portion of the seat broke.

    The dealer told me that they do not have part listings for the
    components of the power seat assembly and that the entire seat would
    need to be replaced (I am not positive that this information was valid
    -- you may want to double check it).

    In the end I found a power seat at a junk yard relatively cheaply
    (because the junk yard seat material was completely trashed) and was
    able to move the entire assembly that adjusts the seat position
    (basically the base of the seat) from the junk yard seat to my "good"
    seat.

    This solved the problem for me.

    Hope this helps,

    Alex
     
    april1st, Jul 13, 2007
    #2
  3. wr2002

    Joe Guest

    There are a bunch of gears in there, so you've stripped or broken one.
    You'll just have to replace it. If you're mechanically inclined, you might
    be able to convince it to lower working on it yourself, but if you could do
    that, you probably wouldn't have posted this.
     
    Joe, Jul 13, 2007
    #3
  4. wr2002

    afx Guest

    Same thing happened to me once, it was just the little cable had
    popped out of the motor, Ide try taking the seat out and seeing if
    that is in correctly, if not, try replacing with the passenger motor
    or a junk yard motor.
     
    afx, Jul 14, 2007
    #4
  5. wr2002

    Ken Weitzel Guest

    Hi...

    If you do use the passenger seat motor, make sure you put that seat
    in a nice general "fits all" position first :)

    Take care.

    Ken
     
    Ken Weitzel, Jul 14, 2007
    #5
  6. wr2002

    philthy Guest

    there is a recall on the dr. seat recliner drive if that helps
     
    philthy, Jul 15, 2007
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.