2001 T&C Passenger power Window

Discussion in 'General Motoring' started by ddm, Jun 2, 2006.

  1. ddm

    ddm Guest

    How do you remove the side panel on passenger side of 2001 T&C limited
    I have a window which stops 1 inch from top and need to take door apart
    to investigate the problem
    I took out three screws but could not remove panel
    What have I missed?
     
    ddm, Jun 2, 2006
    #1
  2. ddm

    maxpower Guest

    --

    You lost me on this, what side panel are you referring to?

    Glenn Beasley
    Chrysler Tech
     
    maxpower, Jun 2, 2006
    #2
  3. ddm

    ddm Guest

    inside door panel
     
    ddm, Jun 3, 2006
    #3
  4. ddm

    maxpower Guest

    --

    There may be 2 hidden screws in the lower part of the panel where the carpet
    is if you have carpet. just feel around for 2 holes, if so... a Phillips
    screw driver is needed.
     
    maxpower, Jun 3, 2006
    #4
  5. ddm

    philthy Guest

    there is five door panels both front, l&r both sliders if equiped and the rear.

    once all the screws are out then pop off the panel hard! plastic clips hold it
    in place and the clips are stronger than the metal of the door
     
    philthy, Jun 3, 2006
    #5
  6. ddm

    ddm Guest

    Finally got it
    There were three screws. I had to pry hard to remove panel as there are
    several plastic clips on the panel. Nothing broke but it is difficult
    to remove.
    I used a flat pry bar with a V to insert under some of the clips-this
    made it easier to pop off the clips.

    Door repaired-thanks
     
    ddm, Jun 4, 2006
    #6
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.