2001 T&C backup sensors install

Discussion in 'General Motoring' started by Dan, Jan 22, 2008.

  1. Dan

    Dan Guest

    Does anyone know if there are any markings molded into the inside of the
    plastic bumper cover to show where the sensors should be installed.The
    spacing between the cover and the bumper is very tight and I don't want to
    screw up. I am speaking about the back bumper.Thanks in advance Dan
     
    Dan, Jan 22, 2008
    #1
  2. Dan

    maxpower Guest

    Dan If you are installing a Chrysler System, it should have come with a
    template. the rear bumper fascia would have to be removed to set up the
    holes.

    Glenn Beasley
    Chrysler Tech
     
    maxpower, Jan 22, 2008
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Which Trailer Hitch to Install on Voyager-?

  2. T&C backup sensor add-ons?

  3. T&C backup sensors add-on ?

  4. '02 Jeep Grand Cherokee (Backup Noise)

  5. backup light bulb upgrade

  6. solution to weak backup lights

  7. Anyone install "park assists" (backup sensors) on their car?

  8. '06 Sebring backup lights

Loading...