2.6l Mitsubishi motor question

Discussion in 'General Motoring' started by Jean Marc Lachance, Nov 3, 2003.

  1. Jean Marc Lachance

    Jean Marc Lachance Guest

    I'm replacing the motor in my 85 Voyager (trying to get it to run till it's
    20 years old). The engine I'm taking out was a rebuilt and at that time
    they had eliminated the silent shaft and counter balance. The better but
    older engine I'm putting in has the silent shaft but the guides for the
    counter balance chain need replacing. If I simply eliminated the silent
    shaft and use the same set up on this engine as the (no good) rebuilt (
    small chain to oil pump), would there be any other modifications to do? Was
    the silent shaft set-up simply to avoid vibrations and is it common on
    timing chain engines?

    Thanks

    JML


    Take off thehat to reply
     
    Jean Marc Lachance, Nov 3, 2003
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Question on checking valve lift 360 motor.

  2. dodge / chrysler / mitsubishi colt 200 1989

  3. Junkyard survey of 3.0L Mitsubishi

  4. 95 chrysler Lebaron 3.0L Mitsubishi V6 404t auto trans. Stalls while driving...

  5. Compression drops 40-PSI after 500 miles - normal? [Mitsubishi/Dodge Eclipse-Talon `94, 1.8 lt.]

  6. 83 Chrysler with 2.6 mitsubishi engine- chain noise

  7. Mitsubishi 2.6 Reassembly Puzzle

  8. Timing belt replacement '99 3.0 Mitsubishi

Loading...