2.5 Chrysler Rear cam seal vs Plug?

Discussion in 'General Motoring' started by Adam Jacobs, Jan 27, 2006.

  1. Adam Jacobs

    Adam Jacobs Guest

    I'm finishing up a rebuild on a 2.5 4-cylinder, and I noticed that my
    rebuild kit came with a standard rear cam seal and the original seal was
    the "plug" type. Is there much difference? Should I look into finding a
    plug to use?
     
    Adam Jacobs, Jan 27, 2006
    #1
  2. Adam Jacobs

    kmatheson Guest

    When I had the valve work done on my 2.5, they replaced the rear seal
    with one just like the original. The *plug* type as you say. I would
    think that the rebuild kits would supply the same one.

    You might check to see what other vendor's kits provide.

    -Kirk Matheson
     
    kmatheson, Jan 27, 2006
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Neon CAM seal leak.

  2. Can you identify this cam?

  3. '99 Intrepid - turn signal cam

  4. Location of cam sensor 99 3.2 intrepid

  5. 96 3.3 Dodge just stopped. Cam & crank sensors changed w/ASD. Spark hits one time only at each try.

  6. 2003 Dodge intrepid 2.7 engine cam tone ring swap question?

  7. Cam & Crank Sensor resistance values

Loading...