1995 Voyager half shaft woes

Discussion in 'Voyager' started by paulthetwo, Jun 19, 2006.

  1. paulthetwo

    paulthetwo Guest

    1995 Plymouth Voyager, 3.0 ltr, 144,000 miles

    inner CV joint shredded, went to replace half shaft, cannot get shaft
    to pull out of trans!!
    I have pryed, pulled cussed and yanked. I have replaced half shafts
    before, never anything like this.
     
    paulthetwo, Jun 19, 2006
    #1
  2. paulthetwo

    kmatheson Guest

    I assume that you have removed the nut from the bearing, separated the
    strut from the lower ball joint, and pulled the struct clear of the
    shaft. There really shouldn't be anything else holding it.

    -KM
     
    kmatheson, Jun 19, 2006
    #2
  3. paulthetwo

    Joe Pfeiffer Guest

    I've seen rust get started in there, at which point getting the
    half-shaft out resemebled the OP's description pretty closely.
    Swearing louder seemed to be just about the only thing that helped.
     
    Joe Pfeiffer, Jun 19, 2006
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 89 Dynasty 3.0 half-shaft

  2. 97 Plymouth Grand Voyager Transmission Woes

  3. Half of a Stereo.

  4. trouble changing CV joint ( half shaft) 93 Grand Caravan

  5. Delphi Proposal to Cut Wages in Half!

  6. Front Drive Axle ('half shaft") replacement - 2001 Intrepid

  7. heat working in half the minivan

  8. Energy Bill Has Only Half a Tank

Loading...