1992 New Yorker Transaxle Issue

Discussion in 'General Motoring' started by jason.koval, Feb 4, 2007.

  1. jason.koval

    jason.koval Guest

    I have a 1992 New Yorker with a 3.8 and only 46,000 miles on it. The
    transaxle will not go into gear (either forward or reverse) right away
    on a cold start most of the time and it will occasionally slip under
    load. If I give it some gas it will usually go into gear but it will
    be locked in 2nd until I stop and restart it, which I know is a
    Chrysler safety feature. I have had the fluid and filter changed
    twice within the past 500 miles and no garage can find any problem
    with the transaxle. The computer shows no codes. My question is
    could a bad TCM cause these symptoms or should I be looking at
    something else first? Could the TCM need a firmware upgrade? I think
    there is a TSB on this? Thanks.
     
    jason.koval, Feb 4, 2007
    #1
  2. jason.koval

    DanHayes Guest

    I have an engine and trans from a 1993 dodge dynasty i am willing to sell...
    it has a 3.3v6 and a a604/41te trans ( the same as my 1992 fifth avenue.
    Other parts for sale please email
     
    DanHayes, Apr 15, 2007
    #2
  3. jason.koval

    OldRoads Guest

    OldRoads, Apr 19, 2007
    #3
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. 1997 1/2 voyager 3.0L 3spd transaxle, 75000mi, just blew up the transmission.

  2. 1992 Chrysler New Yorker Fifth Avenue

  3. Dune Buggy with FWD Mopar Engine/Transaxle Combo

  4. Left Transaxle Shaft Seal

  5. Omni-Horizon transaxle and engine attach points

  6. 1992 Chrysler New Yorker 'Salon' trunk light indicator

  7. 1992 New Yorker hard starting problem

  8. Curt trailer hitch #12025

Loading...